Ensure that the user configured to bind to the LDAP server is an actual administrator of the LDAP engine (i.e. notAllowedOnNonLeaf (66) Indicates that the operation is inappropriately acting upon a non-leaf entry. Watson Product Search Search None of the above, continue with my search Data codes related to 'LDAP: error code 49' with Microsoft Active Directory LDAP: error code 49; MSAD; validate-ldap; Active LDAP Error Messages LDAP Error MessagesThis section provides help in resolving Lightweight Directory Access Protocol (LDAP) error messages.Cannot Open LDAP Connection to Local Host or Run Admin Tools ErrorThe "Cannot open Check This Out
If possible, try an account with higher permissions temporarily to isolate the problem. 53 The LDAP server cannot process the request because of server-defined restrictions. Compare operations will not return a success result. AuthenticationNotSupportedException 8 Strong authentication required. In an unsolicited notice of disconnection, the LDAP server discovers the security protecting the communication between the client and server has unexpectedly failed or been compromised. 9 Reserved. 10 LDAP_REFERRAL Does
affectsMultipleDSAs (71) Indicates that the operation cannot be performed as it would affect multiple servers (DSAs). Answer Hex Decimal Description 0x00 0 LDAP_SUCCESS: Indicates the requested client operation completed successfully. 0x01 1 LDAP_OPERATIONS_ERROR: Indicates an internal error. H.19. AuthenticationNotSupportedException 9 Partial results being returned.
H.14. Yes No Thanks for your feedback! Binding with DN for non-anonymous search (cn=public-ldap,ou=Garda1UserTS,ou=service accounts,dc=garda1,dc=tlc). Ldap Error Code 49 Data 775 Data 533 The user's account has been disabled Enable the user account in Active Directory Data 701 The user's account has expired Ensure that "Never" is set as the account expiration
InvalidAttributeValueException 20 An attribute or value already in use. notAllowedOnRDN (67) Indicates that the operation is inappropriately attempting to remove a value that forms the entry's relative distinguished name. The constraint can be one of size or content (string only, no binary). 0x14 20 LDAP_TYPE_OR_VALUE_EXISTS: Indicates the attribute value specified in a modify or add operation already exists as a In NDS 8.3x through NDS 7.xx, this was the default error for NDS errors that did not map to an LDAP error code.
Returns only when presented with valid username and password credential. 49 / 773 USER MUST RESET PASSWORD Indicates an Active Directory (AD) AcceptSecurityContext data error. Ldap Error Code 49 Acceptsecuritycontext In a client request, the client requested an operation such as delete that requires strong authentication. H.24. Error Message: Success cn=public-ldap,dc=garda1,dc=tlc Result Messages Binding with DN for non-anonymous search (cn=public-ldap,dc=garda1,dc=tlc).
For an extended operation, it may indicate that the server does not support the extended request type. Indicates that the results of a compare operation are false. 0x06 6 LDAP_COMPARE_TRUE: Does not indicate an error condition. Ldap: Error Code 49 - 80090308 Please check the data code in the error message. Ldap Error Code 49 - Invalid Credentials invalidDNSyntax (34) Indicates that an LDAPDN or RelativeLDAPDN field (e.g., search base, target entry, ModifyDN newrdn, etc.) of a request does not conform to the required syntax or contains attribute values
strongerAuthRequired (8) Indicates the server requires strong(er) authentication in order to complete the operation. his comment is here compareFalse (5) Indicates that the Compare operation has successfully completed and the assertion has evaluated to FALSE or Undefined. I tried to test by the LDAP test tool to the LDAP server, it connected, but when testing with the parameters in Configure Drupal picture, I tried to fill in the Using password entered in form. Ldap Error Code 32
saslBindInProgress (14) Indicates the server requires the client to send a new bind request, with the same SASL mechanism, to continue the authentication process (see RFC4511 Section 4.2). Note that this does not necessarily mean that the associated operation was aborted in the server, and it is entirely possible that an operation that was canceled on the client still In the JNDI, error conditions are indicated as checked exceptions that are subclasses of NamingException. this contact form Sounded like a simple project, at the beginning.
JIRA, Confluence etc) does not have sufficient rights to perform the requested operation. Note that at present, the numeric value for this result code is not an official standard because the specification for the no operation request control has not progressed far enough to Target finished: action-validate-ldap-was-admin-user Cause The error shown below is similar each time there is an LDAP authentication issue. "The exception is [ LDAP: error code 49 - 80090308: LdapErr: DSID-0Cxxxxxx, comment: Ldap: Error Code 49 - 80090308: Ldaperr: Dsid-0c0903d0 It wasn't accurate It wasn't clear It wasn't relevant Submit feedback Cancel Have a question about this article?
ldap error #49 Invalid credentials this is my ldap server configuration: Server Properties sid = garda1pdc name = garda1pdc status = 1 ldap_type = ad address = 192.168.21.1 port = 389 Using password stored in configuration Binding with DN for non-anonymous search (cn=public-ldap,dc=garda1,dc=tlc). Code Description Resolution Data 525 The user could not be found Ensure the correct username has been specified for the bind account. navigate here undefinedAttributeType (17) Indicates that a request field contains an unrecognized attribute description.
See the Naming Exceptions section for an overview of the JNDI exception classes. Either the server does not support the control or the control is not appropriate for the operation type. 13 LDAP_CONFIDENTIALITY_REQUIRED Indicates that the session is not protected by a protocol such NoSuchAttributeException 17 An undefined attribute type. Watson Product Search Search None of the above, continue with my search What are the LDAP return codes and message descriptions?
The add or modify operation tries to add an entry with a value for an attribute which the class definition does not contain. Usually, this indicates an error at the LDAP server, rather than a problem with the request that was made. SchemaViolationException 71 Affects multiple DSAs. For product-specific information, please see your product documentation.
Ensure that the base DN is correct and free from typographical errors. 12 Sun Directory Server does not support Paged Results which generates an error like: org.springframework.ldap.OperationNotSupportedException: [LDAP: error code 12 Either the server does not support the control or the control is not appropriate for the operation type. 0x0D 13 LDAP_CONFIDENTIALITY_REQUIRED: Indicates the session is not protected by a protocol such Binding with DN for non-anonymous search (cn=ldapsearch,dc=bus,dc=local). unwillingToPerform (53) Indicates that the server is unwilling to perform the operation.
Failed to bind to server. Documentation The Java™ Tutorials Download Ebooks Download JDK Search Java Tutorials Hide TOC Advanced Topics for LDAP Users LDAP v3 JNDI as an LDAP API How LDAP Operations Map to JNDI In your php, can you do an ldap search (see. The exception is javax.naming.AuthenticationException: [LDAP: error code 49 - 80090308: LdapErr: DSID-0C090334, comment: AcceptSecurityContext error, data 775, vece ] at com.sun.jndi.ldap.LdapCtx.mapErrorCode(LdapCtx.java:3005) In this case, validate-ldap is the config task that was
objectClassModsProhibited (69) Indicates that an attempt to modify the object class(es) of an entry's 'objectClass' attribute is prohibited. inappropriateMatching (18) Indicates that an attempt was made (e.g., in an assertion) to use a matching rule not defined for the attribute type concerned. constraintViolation (19) Indicates that the client supplied an attribute value that does not conform to the constraints placed upon it by the data model. H.15.
busy (51) Indicates that the server is too busy to service the operation. Log in or register to post comments Comment #2 erasmo83 CreditAttribution: erasmo83 commented May 30, 2012 at 3:29pm Thanks for reply I try with this lines of code: $ldap = ldap_connect("garda1.tlc"); Password restrictions prevent the action.